B242A BMW Fault Code

Description:

The Throttle Position sensor signals the Engine Control Module as to the current position of the engine throttle valve.
The current throttle valve opening is based on the driver's input from the gas pedal.

The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.

B242A Code Symptoms :

When you turn on the ignition, the Service Engine Soon or Check Engine B242A light should flash briefly, indicating that the OBD system is ready to scan your vehicle for any malfunctions. After this brief flash, the light should stay off while you drive as long as no problems are detected. If so, you'll be glad to know that your vehicle is equipped with an early warning system that could save you time, money, and fuel in addition to helping protect the B242A!

Diagnosis And Repairing B242A

B242A OBD 2 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.

How to fix B242A code ?

• Faulty Air Flow Meter
• Faulty Fuel injector
• Intake Valve Timing Control Solenoid Valve harness is open or shorted
• Open VPWR circuit

Some systems require that the actuator has an adequate supply of brake fluid. Low brake fluid levels can mimic the symptoms of code B242A, so consult the manual to locate the brake fluid reservoir.

Bear in mind that a low fluid level can set code B242A on some applications, so make sure that on fluid operated systems the fluid level is up to the mark before starting an electrical diagnosis.